­
Back To Category
0060 Metal Valley Flashing Alternate - Roofing - Steep Roof Flashings - Valley Flashings
 
0060 Metal Valley Flashing Alternate - Roofing - Steep Roof Flashings - Valley Flashings -

Image Text: Nails not more than 18 inches on-center and located 1 inch away from edges > metal valley flashing with total width of at least 24 inches - centered in valley > ice and water shield extending under edge of metal flashing to > A: make nail holes more watertight > B: extend width of flashing by 18 inches on each side > C: provide some extra adhesion of the metal flashing to the roof > at least 12 inches on each side of the valley

Powered by Phoca Gallery

Image courtesy of Carson Dunlop. To purchase images, go to CarsonDunlop

ROOFING, Steep Roofing , General, Asphalt Shingles, Wood Shingles and Shakes, Slate , Clay, Concrete and Fiber Cement, Metal, Roll Roofing, Steep Roof Flashings, Valley Flashings, Chimney Flashings, Plumbing Stack Flashings, Roof/Wall Flashings, Hip and Ridge Flashings, Skylights, Solariums, Drip Edge Flashings, Dormer Flashing, Flat Roofing, General , Built-Up Roofing (Tar and Gravel), Modified Bitumen, Synthetic Rubber (Elastomeric, EPDM), Plastic Roofing (PVC, Thermoplastic), Roll Roofing, Flat Roof Flashings

­