­

 

If You Hire A Corrective-Action Contractor

  • Check with your local air pollution control board, the local agency responsible for worker safety, and the Better Business Bureau. Ask if the firm has had any safety violations. Find out if there are legal actions filed against it.

  • Insist that the contractor use the proper equipment to do the job. The workers must wear approved respirators, gloves, and other protective clothing.

  • Before work begins, get a written contract specifying the work plan, cleanup, and the applicable Federal, State, and local regulations which the contractor must follow (such as notification requirements and asbestos disposal procedures). Contact your State and local health departments, EPA's regional office, and the Occupational Safety and Health Administration's regional office to find out what the regulations are.

  • Be sure the contractor follows local asbestos removal and disposal laws. At the end of the job, get written assurance from the contractor that all procedures have been followed.

  • Assure that the contractor avoids spreading or tracking asbestos dust into other areas of your home. They should seal the work area from the rest of the house using plastic sheeting and duct tape, and also turn off the heating and air conditioning system. For some repairs, such as pipe insulation removal, plastic glove bags may be adequate. They must be sealed with tape and properly disposed of when the job is complete.

  • Make sure the work site is clearly marked as a hazard area. Do not allow household members and pets into the area until work is completed.

  • Insist that the contractor apply a wetting agent to the asbestos material with a hand sprayer that creates a fine mist before removal. Wet fibers do not float in the air as easily as dry fibers and will be easier to clean up.

  • Make sure the contractor does not break removed material into small pieces. This could release asbestos fibers into the air. Pipe insulation was usually installed in preformed blocks and should be removed in complete pieces.

  • Upon completion, assure that the contractor cleans the area well with wet mops, wet rags, sponges, or HEPA (High Efficiency Particulate Air) vacuum cleaners. A regular vacuum cleaner must never be used.

  • Wetting helps reduce the chance of spreading asbestos fibers in the air. All asbestos materials and disposable equipment and clothing used in the job must be placed in sealed, leak proof, and labeled plastic bags. The work site should be visually free of dust and debris. Air monitoring (to make sure there is no increase of asbestos fibers in the air) may be necessary to assure that the contractor's job is done properly. This should be done by someone not connected with the contractor.

CAUTION

  • Do not dust, sweep, or vacuum debris that may contain asbestos. These steps will disturb tiny asbestos fibers and may release them into the air. Remove dust by wet mopping or with a special HEPA vacuum cleaner used by trained asbestos contractors.

Log in to comment
­